Find your manual in our Disassemble database ...
     HOME      | Mobile phones | Laptops nad netbooks | Desktop PC | Monitors and screens |      OTHER

Can't find what you need? Request a disassembly manuals and we will try to locate it and add it to our database.

 » Pinout.net - Disassemble Database »  InFocus Work Big IN36 SP-LAMP-026 Bulb Replacement


If you like this manual recomend it to your friends...


   
   
  1. Turn off the projector and unplug the power cable.
  2. Wait 60 minutes to allow the projector to cool thoroughly.

    Infocus-SP-LAMP-026-Replacement-Lamp

  3. Turn the projector upside down and remove the lamp door by placing a flat-blade screwdriver into the space between the lamp door and the projector and gently prying the door off.

    Infocus-SP-LAMP-026-Replacement-Lamp-bulb

  4. Loosen the captive screw on the lamp module

    Infocus-SP-LAMP-026-Lamp-Replacement

    WARNINGS:
    •To avoid burns, allow the projector to cool for at least 60 minutes before you replace the lamp.
    •Unplug the power cord before replacing the lamp.
    •Do not drop the lamp module. The glass may shatter and cause injury.
    •Do not touch the glass lamp screen. Fingerprints can obscure projection sharpness.
    •Be extremely careful when removing the lamp housing. In the unlikely event that the lamp ruptures, small glass fragments may be generated. The lamp module is designed to contain most of these fragments, but use caution when removing it. Before replacing a ruptured lamp, clean the lamp compartment and dispose of cleaning materials. Wash hands after lamp replacement. This product has a lamp which contains a very small amount of mercury. Dispose of it as required by local, state or federal ordinances and regulations.

    Infocus-SP-LAMP-026-Bulb-Replacement-Lamp-projector

  5. Detach the lamp connector from the projector by gently pulling the connector until it is disconnected from the projector.
  6. Carefully remove the lamp module by grasping and lifting the metal bail wire. Dispose of the lamp in an environmentally proper manner.

    Infocus-SPLAMP026-Lamp-Replacement

  7. Install the new lamp module, making sure that it is properly seated. Be careful not to touch the interior components of the projector.
  8. Snap the bail wire back into its flat position against the lamp module.
  9. Re-attach the lamp connector to the projector. Make sure the connector is fully inserted.
  10. Tighten the screw on the lamp module.
  11. Replace the lamp door.
  12. Plug in the power cable then press the Power button to turn the projector back on, then reset the lamp hour timer.
    


If you like this manual recomend it to your friends...
Search for Disassembly manuals
PinoutMaster team 2005 - 2024 Service manuals - Car Audio Unlock- Elemetnt Datasheets-