Information about cable, connector or adapter : IEEE 488 (GPIB / HPIB)  

BUY CHEAP ieee 488 (gpib / hpib)

 IEEE 488 (GPIB / HPIB)
 Originally developed by :
 Copyright :
 Source :
 Category :   All cables and connectors > Connectors > Computer > Buses >
 Added to database : 2005-07-13 02:36:44



 Description : PINOUT: IEEE 488 (GPIB / HPIB)
Click/Tap on image to ZOOM

 
IEEE 488 (GPIB / HPIB)

 female
Click/Tap on image to ZOOM

 
IEEE 488 (GPIB / HPIB)

 male

 Pinout : 0


PinNameDirectionColorDescription
1Data I/O 1
2Data I/O 2
3Data I/O 3
4Data I/O 4
5EOI End Or Indentify has two uses. EOI is asserted on the last byte of a data transfer. This signals all devices that no more data should be expected on the transfer.
6DAV Data Valid is a handshake line indicating that the active talker has placed data on the data lines.
7NRFDNot Ready For Data is a handshake line indicating that one or more active listeners is not ready for more data. Note the active talker should then wait before sending any more data on the bus.
8NDAC Not Data Accepted is a handshake line indocating that one or more active listeners has not accepted the current data byte. Note the active talker should leave the current byte asserted on the data lines until it has been accepted ot timed out.
9IFC Interface Clear is under the exclusive control of the system controller. When it is active high all devices on the bus are returned to an idle state and the bus is cleared
10SRQ Service Request can be set by a devive on the interface to indicate it is in need of service. SRQ could be set at the completion of a task. E.g. finished doing a measurement, or when an error as occurred.
11ATN Attention is used primarily to differentiate between command mode and data mode. When ATN is TRUE (I.E. Active high) information on the bus is a command and when ATN is FALSE (Active LOW) the information on the bus is data.
12 SHIELD GROUND(Earth)
13Data I/O 5
14Data I/O 6
15Data I/O 7
16Data I/O 8
17REN Remote Enable may be set by the system controller to allow other devices to operate in remote mode.
18P/O Twisted pair with 6
19P/O Twisted pair with 7
20P/O Twisted pair with 8
21P/O Twisted pair with 9
22P/O Twisted pair with 10
23P/O Twisted pair with 11
24 SIGNAL GROUND

 Note : PINOUT: IEEE 488 (GPIB / HPIB)
COMMENTS:



Search for Disassembly manuals
PinoutMaster team 2005 - 2024 Service manuals - Car Audio Unlock- Elemetnt Datasheets-